GftK international GmbH – leading manufacturer of jointing mortars

Pictogramme Fugenmörtel

vdw 840plus Paving Joint Mortar 1-component

vdw 840 plus
Paving Joint Mortar 1-component
For pedestrian areas
Icon Fußgänger
weitere Eigenschaften: 

For the jointing of natural stone setts and concrete block paving, including paving slabs and brick paving etc. Suitable for pedestrian traffic only i.e. for garden patios, paths, domestic-entrance areas and terraces.

  • Supplied ready-to-use
  • Wet slurry application
  • Can be applied in light rain
  • Suitable for narrow joints from 3mm to 20mm
  • Paving surfaces remain almost free from residual binder, any that does remain will disappear with weathering
Colors Sample Packaging Article no. Packaging Article no.
natural 12,5 kg 840302.812 25 kg 840302.825
sand beige 12,5 kg 840307.812 25 kg 840307.825
stone grey 12,5 kg 840303.812 25 kg 840303.825
basalt 12,5 kg 840304.812 25 kg 840304.825


Verarbeitung / Application: 

ln comparison with other air-drying 1-component joint compounds, vdw 840plus 1K-jointing mortar stands out due to its higher strength and better strength correlation, plus its unique moisture tolerance that allows the option of "wet" slurry application, with greater retention of strength and other performance characteristics.

Solid and permeable supporting structure, joint depth ≥ 30mm, joint width min. 3mm / max. 20mm, ambient and object temperature ≥ 5°C, max. 30°C.

Knife, squeegee, coconut fibre brush and water hose with spray nozzle.

Test area:
On some stones, experinece has shown that the contact between vdw 840 plus 1K-Jointing mortar and the stone surface can make the stone appear darker, or to have a 'wet look'. In general the product should be tested first.

Clean the surface of the paving area to remove all dirt, cement, sand, or other materials.

Cut open the plastic bag. Fully saturate the pavement surface. Pour the mortar onto the wetted surface in small piles. Slurry into the joints using a soft water jet and a hard rubber squeegee. Clean any surplus mortar from the surface carefully using more water and a dampened coconut fibre brush. Be careful not to brush out the freshly applied mortar in the joints. Chamfers must be brushed free carefully, as performance cannot be guaranteed on these. A slight binder film might remain, depending on the kind of stone.

Anyway, please follow our detailed technical hints for the application of our products which are available free of charge. Subject to technical changes. When in doubt, please contact us. Our general conditions of sale apply.

Gesellschaft für technische Kunststoffe mbH
Kottenforstweg 3
D-53359 Rheinbach-Flerzheim
Tel: +49 (0) 22 25 / 91 57-0
Fax: +49 (0) 22 25 / 91 57-60


Service Hotline


Protection of data privacy: This webpage uses Google Analytics.

More / Disable tracking